Briggs Stratton Lawn Mower 5021029 User Manual

Engine Spacer Replacement Kit  
Installation  
Part No. 5600094  
For Ferris 27HP Kohler IS2000Z Models and Simplicity Cobalt Models  
Instructions  
Kit Contents:  
Part No.  
5044062  
5045289  
5021029  
Qty. Description  
1
1
1
Spacer, 1.13 X 1.75 X .50  
Bolt, Crankshaft, 7/16 X 2-1/2”  
Tie Wrap, 11” long  
WARNING  
Before beginning any service work turn off the  
PTO, set the parking brake, turn off the ignition,  
and disconnect the spark plug wire(s).  
INSTALLATION  
1. Park machine on a flat, level surface and engage the  
parking brake. Disengage the PTO switch, turn off  
the engine and remove the key from the ignition.  
G
2. Remove the PTO clutch belt.  
H
3. Cut the tie wrap that secures the PTO clutch wires  
(E, Figure 1) to the PTO clutch anchor bracket (G).  
Disconnect the PTO clutch wires from the main wire  
harness.  
F
4. Remove the 5/16” nylock flange nut (D) that secures  
the PTO clutch anchor pad (F) to the PTO clutch (B).  
A
NOTE: Before removing the PTO clutch observe and  
remember the clutch orientation to the clutch anchor pad  
for reinstallation later.  
E
B
5. Loosen and remove the crankshaft bolt (C), the PTO  
clutch (B) and the crankshaft spacer (A). Discard the  
old crankshaft bolt and the old spacer.  
C
D
6. Install the new crankshaft spacer with the rounded  
edge on the inside of the spacer facing up toward the  
pulley (H). Reinstall the PTO clutch in the same  
orientation that it was removed in Step #5 and  
secure with the new crankshaft bolt. Torque the  
crankshaft bolt to 65 ft-lbs (88Nm).  
Figure 1. Replacing the Engine Spacer  
A. Crankshaft Spacer  
B. PTO Clutch  
C. Crankshaft Bolt  
D. 5/16” Nylock Flange Nut  
E. PTO Clutch Wires  
7. Reinstall the 5/16” nylock flange nut to secure the  
PTO clutch anchor pad to the PTO clutch.  
F. PTO Clutch Anchor Pad  
G. PTO Clutch Anchor Bracket  
8. Reconnect the PTO clutch wires to the main wire  
harness. Pull the wire slack away from all belts and  
pulleys and secure to the PTO clutch anchor bracket  
with the tie wrap.  
9. Reinstall the PTO clutch belt.  
Briggs & Stratton Yard Power Products Group  
Copyright © 2006 Briggs & Stratton Corporation  
Milwaukee, WI, USA. All Rights Reserved.  
5402677  
Rev.12/2006  
TP 200-7322-00-SK-FS  
1
 

Black Decker Iron AS202 User Manual
Blanco Indoor Furnishings 501 103 User Manual
Bosch Appliances Range HES7282U User Manual
Bush Hog Lawn Mower Subcompact Box Blades User Manual
Cadco Food Warmer CMLB 24P User Manual
Cadco Microwave Oven CAPO 6403S User Manual
Canon Camcorder 2694B001 User Manual
Cateye Bicycle Accessories CC CD200N User Manual
Chauvet Scanner Q RollTM 250 User Manual
Cisco Systems IP Phone OL 15790 01 User Manual